Banner QMT72 Rope Pull Switches User Manual

Datasheet• Positive-opening safety contacts (IEC 60947-5-1), not dependentupon springs• Both safety contacts latch open when rope is pulled or in case

Model Quantity Description ClampRPA-CC2-4 4 Clamp for 3 mm wire ropeModel Quantity Description TurnbuckleRPA-TA1-1 1 #4 TurnbuckleModel Quantity Descr

Model Max. RopeLengthRun Position Cable Pulled Cable Break Switching DiagramRP-QMT72D-20L 20 m (65 ft) 25 2613 14 25 2613 14 25 2613 14 13-1425-26Br

Important... Read This FirstRegarding the Use of Rope Pull Switches. In the United States, the functions that Banner rope pull switches areintended to

Reset Button Pull to ResetRope Tension IndicatorCover Plate Screws (4)Figure 1. FeaturesThese rope pull switches are not safeguarding devices, in that

150 mm(6") max.L1L225 mm(1") min.400 mm (16") max.for Actuation of SwitchNOTE: Force to actuate must not exceed 200 N (45 lbf)Figure

Figure 5. Rope Break or Slack: Contact 13/14 (33/34) OpensElectrical Installation13251426InstallJumper WireBetweenContactsTo MachineControlStopCircuit

Important: If instructed to return the device, pack it with care. Damage that occurs in return shippingis not covered by warranty.SpecificationsContac

DimensionsM2082.0 mm(3.23")72.0 mm(2.83")56.0 mm(2.21")33.0 mm(1.30")53.0 mm(2.09")Ø 15.0 mm (0.59")7.0 mm(0.28")40

AccessoriesCable GlandsModel SizeFor CableDiameterDimensions Used WithSI-QM-CGM20 M20 × 1.5 Metal5.0 to 12.0 mm(0.20 to 0.47inches)M20 x 1.524.0 mm(0.