Banner SureCross DX81H Battery Supply Module User Manual download pdf

Datasheet

• Wireless solution for powering a DX99 FlexPower Node and sensor device in

Class I, Division 1, Groups A, B, C, D; Zone 0, Group IIC environments

• Unique power management system to run the FlexPower Node and a device

through switched power outputs

• Replaceable 3.6 V dc Lithium “D” cell battery

• IP67 sealed enclosure

FlexPower systems allow for a true wireless solution as the Node can be powered by

battery power (3.6 to 5.5 V dc). Battery life is application specific. Contact Banner

Engineering’s application engineers for a battery life calculation for your specific

application.

For additional information, updated documentation, and accessories, refer to Banner Engineering's website,

www.bannerengineering.com/surecross.

Model

Power Batteries Cable

DX81H 3.6 V dc battery One 3.6 V Lithium "D" Cell 5-pin Euro pigtail QD

5-pin Euro-Style Female Wiring for DX81H

Only FlexPower

DX99 devices may be powered from this supply.

5-pin Euro-style Female Connector

No. Wire Color Description

3 Blue dc common (GND)

5 Gray

3.6 V dc

Replacing the Battery (DX81 and DX81H Battery Supply Module)

For outside or high humidity environments, apply conductive grease to the battery terminals to prevent moisture and

corrosion buildup.

To replace the lithium "D" cell battery in the DX81 FlexPower

battery kit, follow these steps.

1. Unplug the battery device from the SureCross device it powers.

2. Remove the four screws mounting the battery pack face plate to the body and remove the face plate.

3. Remove the discharged battery by pressing the battery towards the negative terminal to compress the spring. Pry up

on the battery’s positive end to remove from the battery holder.

4. Replace with a new battery. Only use a 3.6 V lithium battery from Xeno, model number XL-205F.

5. Verify the battery’s positive and negative terminals align to the positive and negative terminals of the battery holder

mounted within the case. Caution: There is a risk of explosion if the battery is replaced incorrectly.

Do not apply more than 5.5 V dc to the gray wire.

SureCross DX81H Battery Supply Module

for the DX99

P/N 141517 Rev. B 2 January 2014

0 141517 9

1 2 3

Summary of Contents

Page 1 - Datasheet

Datasheet• Wireless solution for powering a DX99 FlexPower Node and sensor device inClass I, Division 1, Groups A, B, C, D; Zone 0, Group IIC environm

Page 2 - Specifications

6. After replacing the battery, allow up to 60 seconds for the device to power up.7. Properly dispose of your used battery according to local regulati

Page 3 - Warnings

DX81 and DX81H Dimensions65[2.56]65[2.56]124.5[4.90]56.6[2.23]80.9[3.18]WarningsViolating Warnings. The manufacturer does not take responsibility for

Comments to this Manuals

No comments

Banner SureCross DX81H Battery Supply Module User Manual

Browse online or download User Manual for Sensors Banner SureCross DX81H Battery Supply Module. Banner SureCross DX81H Battery Supply Module User Manual

Summary of Contents

Comments to this Manuals

Related products and manuals for Sensors Banner SureCross DX81H Battery Supply Module