Banner MightLam 2700 Specifications

DO NOT DISCARD BOX! (If for any reason you need to ship your machine back and you discard your box you will be responsible for purchasing another one

10 To change the set temperature, depress and hold either arrow down for 3-4 seconds until the display flashes “SU and the current set temperature.

11 Mounting & Laminating... 1. Be sure all laminator parts (i.e. safety shield, feed table, etc.) are in their proper positions and the lamina

12 Cleaning Rubber Rollers: Excessive build-up of adhesive on the rollers may cause poor lamination quality and erratic film movement. Use the fol

13 SENSORROLLERSCORRECT(TOUCHING)HEATEDROLLERSINCORRECT(GAP)SENSORHEATED Trouble-shooting... PROBLEM: LED does not show display when heat switche

14 Do’s and Don’ts... • Read the instruction manual before operating your laminator. • Always run test samples before laminating v

2 CAUTION...READ BEFORE OPERATING DO NOT RUN THE MACHINE IN REVERSE WHEN THERE IS FILM ON THE FRONT ROLLERS, ESPECIALLY HOT FILM. THIS WILL CAUSE

3 Table of Contents For Your Safety... 4 Electrical Safeguards... 4-5 Specific

4 OPERATING INSTRUCTIONS MIGHTYLAM 2700HC For your safety...  Do not connect the laminator to electrical power or attempt to operate it unti

5  Do not leave the laminator power on for extended periods while not in use. Unplug the machine at the end of the day as a precaution agai

6 Loading Film onto Mandrels using 3” core adapters: When the film is loaded properly the core gripper blade will prevent the film from turning on

7 nut on the brake clockwise to increase tension, and counterclockwise to decrease. This action clamps the brake on the mandrel axle creating tensi

8 Pressure Sensitive (PS) Film Loading 1. Place the roll of single sided PS film on the top supply mandrel. Orient it the same way you would poly i

9 Thermal Laminating... 1. Be sure all laminator parts (i.e. safety shield, feed table, etc.) are in their proper positions and